Toyota Celica 2005 Repair Manual page 1164

4 Check P/T squib RH.
Airbag
P/T Squib RH
Sensor
Assembly
→ ←
ON
DLC3
TC
CG
H01021
AB0119
H01079
H10600
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
(c)
DTC B0132/61
(d)
(e)
OK:
H10624
HINT:
Codes other than code B0132/61 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the seat belt pretensioner RH (P/T squib RH)
connector.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0132/61 is not output.
NG Replace seat belt pretensioner RH
(P/T squib RH).
1163
DI−963