Toyota Celica 2005 Repair Manual page 1141

DI−940
4 Check side squib RH.
Side Squib RH
→ ←
DLC3
TC
CG
H01021
AB0119
H10600
H01068
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
ON
DTC B0113/42
H12024
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn the ignition switch to LOCK.
(b) Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
(c) Connect the side airbag assembly RH (side squib RH)
connector.
(d) Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
DTC B0113/42 is not output.
HINT:
Codes other than code B0113/42 may be output at this time, but
they are not relevant to this check.
NG Replace side airbag assembly RH
(side squib RH).
1140