Toyota Celica 2005 Repair Manual page 1153

DI−952
3 Check airbag sensor assembly.
Floor Wire
Side Squib LH
→ ←
SFL+
SFL−
DLC3
CG
TC
H01017
H09671
AB0119
H10600 H01072
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
Assembly
(c)
CHECK:
ON
(a)
(b)
(c)
DTC B0118/46
(d)
(e)
OK:
HINT:
H13044
Codes other than code B0118/46 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect SFL+ and SFL− of the floor
wire connector on the side airbag assembly LH (side
squib LH) side.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0118/46 is not output.
NG Replace airbag sensor assembly.
1152