Toyota Celica 2005 Repair Manual page 1166

3 Check airbag sensor assembly.
Floor Wire
Airbag
P/T Squib RH
Sensor
Assembly
→ ←
PR+ PR−
DLC3
CG TC
H01020
H02139 AB0119
H10600 H01081
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
CHECK:
ON
(a)
(b)
(c)
DTC B0133/62
(d)
(e)
OK:
HINT:
H10625
Codes other than code B0133/62 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect PR+ and PR− of the floor
wire connector on the seat belt pretensioner RH (P/T
squib RH) side.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0133/62 is not output.
NG Replace airbag sensor assembly.
1165
DI−965