Toyota Celica 2005 Repair Manual page 1145

DI−944
4 Check side squib LH.
Side Squib LH
→ ←
DLC3
CG
TC
H01018 AB0119
H10600 H01073
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
(c)
Assembly
(d)
CHECK:
ON
(a)
(b)
(c)
DTC B0115/47
(d)
(e)
OK:
HINT:
H12026
Codes other than code B0115/47 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the side airbag assembly LH connector.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0115/47 is not output.
NG Replace side airbag assembly LH
(side squib LH).
1144