Toyota Celica 2005 Repair Manual page 1147

DI−946
3 Check airbag sensor assembly.
Floor Wire
Side Squib LH
→ ←
SFL+
SFL−
DLC3
CG
TC
H01017
H09671 AB0119
H10600
H01074
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
ON
DTC B0116/48
H13042
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect the connector to the airbag sensor assembly.
(b) Using a service wire, connect SFL+ and SFL− of the floor
wire connector on the side airbag assembly LH (side
squib LH) side.
(c) Connect the negative (−) terminal cable to the battery,
and wait at least 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
DTC B0116/48 is not output.
HINT:
Codes other than code B0116/48 may be output at this time, but
they are not relevant to this check.
NG Replace airbag sensor assembly.
1146