Toyota Celica 2005 Repair Manual page 1176

3 Check airbag sensor assembly.
Floor Wire
P/T Squib LH
→ ←
PL+
PL−
DLC3
CG TC
H01017
H02139 AB0119
H10600 H01084
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
ON
DTC B0137/71
H10631
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect the connector to the airbag sensor assembly.
(b) Using a service wire, connect PL+ and PL− of the floor
wire connector on the seat belt pretensioner LH (P/T
squib LH) side.
(c) Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
DTC B0137/71 is not output.
HINT:
Codes other than code B0137/71 may be output at this time, but
they are not relevant to this check.
NG Replace airbag sensor assembly.
1175
DI−975