Dcb-Map Stack-Unit All Stack-Ports All; Dcb Pfc-Shared-Buffer-Size - Dell C9000 Series Reference Manual

dcb-map stack-unit all stack-ports all

Apply the specified DCB map on all ports of the switch stack.
C9000 Series
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-name
Defaults None
Command Modes CONFIGURATION
Command History
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.3(0.0)
Usage Information The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.

dcb pfc-shared-buffer-size

Configure the maximum amount of shared buffer size for PFC packets in kilobytes.
You must configure the shared buffer size to be less than the total PFC buffer size. If the buffer size and DCB
buffer threshold settings are applied on one or more ports, a validaiton is performed to determine whether
following condition is satisfied: Shared-pfc-buffer-size <= (Total-pfc-buffer-size - Σpfc priority <> buffer-size
on each port, priority).
If the preceding condition is not satisfied by the shared PFC buffer size value, the configuration is not saved
and a system logging message is generated stating that the shared buffer size that you attempt to specify
cannot be configured because of the existing total buffer space on the system being lower than the shared
Enter the name of the DCB map.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON..
Introduced on the S6000-ON.
Introduced on the S4810 and S6000 platforms.
Data Center Bridging (DCB) 721