Dcb-Map - Dell C9000 Series Reference Manual

P-PFC Configuration TLV enabled
F-Application priority for FCOE enabled
I-Application priority for iSCSI enabled
-----------------------------------------------------------------------------------
Interface TenGigabitEthernet 10/1

dcb-map

Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
C9000 Series
Syntax
dcb-map map-name
Parameters
map-name
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes CONFIGURATION
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
Port Role is Manual
DCBX Operational Status is Disabled
Reason: Port Shutdown
Is Configuration Source? FALSE
Local DCBX Compatibility mode is AUTO
Local DCBX Configured mode is AUTO
Peer Operating version is Not Detected
Local DCBX TLVs Transmitted: ERPfi
Total DCBX Frames transmitted 0
Total DCBX Frames received 0
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
Enter a DCB map name. The maximum number of alphanumeric
characters is 32.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
p-PFC Configuration TLV disabled
f-Application Priority for FCOE disabled
i-Application Priority for iSCSI disabled
Data Center Bridging (DCB) 717