Sflow Extended-Switch Enable - Dell S6100 Configuration Manual

Version
9.2(1.0)
Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.
Related Commands
•

sflow extended-switch enable

Enable packing information on a switch only.
Syntax sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
enable
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
7.4.1.0
1486 sFlow
Description
Introduced on the Z9500.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG
port.
sflow enable (Global) — turn sFlow globally.
Enter the keyword enable to enable global extended information.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.