Texas Instruments OMAP5912 Reference Manual page 1546

Multimedia processor device overview and architecture

Hide thumbs Also See for OMAP5912:

Table of Contents

USB OTG Controller

Table 73. USB Signal Multiplexing Modes (Continued)

1) Figure 76 shows typical connectivity for USB pin group 0 acting as USB device.

2) Figure 80, Figure 81, or Figure 82 show connectivity options for USB alternate pin group 2 acting as USB device.

3) Figure Figure 59 shows typical connectivity for USB pin group 0 acting as USB OTG.

4) Figure 63, Figure 64, or Figure 65 show connectivity options for USB alternate pin group 2 acting as USB OTG.

5) Figure 66 shows typical connectivity for USB pin group 0 acting as USB host.

6) Figure 67, Figure 68, or Figure 69 show connectivity options for USB pin group 1 acting as USB host.

7) Figure 70, Figure 71, or Figure 72 show connectivity options for USB pin group 2 acting as USB host.

8) Figure 73, Figure 74, or Figure 75show connectivity options for USB alternate pin group 2 acting as USB host.

9) Figure 89 shows typical connectivity for USB pin group 1 acting as UART1.

10)Figure 77, Figure 78, or Figure 79 show connectivity options for USB pin group 1 acting as USB device.

11) Figure 60, Figure 61, or Figure 62 show connectivity options for USB pin group 1 acting as USB OTG.

12)Figure 63, Figure 64, or Figure 65 show connectivity options for USB alternate pin group 2 acting as USB OTG.

13)Figure 88 shows typical connectivity for USB pin group 1 to USB pin group 2 wrap mode.

14)See connectivity when OMAP5912 acts as the USB host on a transceiver-less link connection to an on-board USB

device (Figure 85 ) using USB TXD/USB TXSE0 signaling.

15)See connectivity when OMAP5912 acts as the USB host on a transceiver-less link connection to an on-board USB

device using USB TXD/USB TXSE0 signaling (Figure 86).

16)See connectivity when OMAP5912 acts as the USB host on a transceiver-less link connection to an on-board USB

device using USB TXD/USB TXSE0 signaling (Figure 87).

Universal Serial Bus (USB)

USB controller ports that are not specifically mentioned for a row of Table 73

are held in a disabled state. When a USB host controller port is disabled, the

port appears to the controller as a disconnected port. When the USB device

controller is not available to a pin group and OTG is not enabled, the USB

device controller sees pin signaling equivalent to USB_RESET.

When an HMC_MODE is selected that can connect a USB multiplexing port

to OMAP5912 device pins, but all of the pins associated with that pin group are

Available for

Available for

Available for

Chapters

Table of Contents