Storm-Control Broadcast (Interface) - Dell C9000 Series Reference Manual

Version
7.6.1.0
7.5.1.0
7.4.1.0
6.5.1.0
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast
traffic is treated as unknown-unicast traffic.

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface (ingress only).
C9000 Series
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [packets_per_second in] command.
Parameters
packets_per_seco
nd in
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Description
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value
option.
Introduced on the E-Series.
Enter the packets per second of broadcast traffic allowed into
the network. The range is from 0 to 33554368.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Storm Control 2128