Storm-Control Broadcast (Interface) - Dell S6000 Reference Manual

Version 6.5.1.0
Usage Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2
Information broadcast traffic is treated as unknown-unicast traffic.

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface (ingress only).
S6000
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [packets_per_second in] command.
Parameters
packets_per_se
cond in
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
1390
Introduced on the E-Series.
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value
option.
Introduced on the E-Series.
Storm Control