Chapter 4 Set Up The Eternus Dx/Af Storage System For Bs2000; Setting The Host Responses - Fujitsu ETERNUS DX S2, ETERNUS DX S3, ETERNUS DX S4, ETERNUS AF Configuration Manual

Chapter 4
Set Up the ETERNUS DX/AF Storage System
for BS2000
This section explains the required special settings for BS2000. For details of how to use
ETERNUSmgr to perform these settings, refer to the "ETERNUSmgr User Guide".
4.1

Setting the Host Responses

The ETERNUS DX/AF storage system Host Response parameters must be set to match the way in which the
server will process the ETERNUS DX/AF storage system request responses.
These parameters are different for each OS, they must be set before connecting the ETERNUS DX/AF storage
system to the server.
When setting the access path using the ETERNUS SF Storage Cruiser, Host Response No. will be set to default
values.
Set the Host Response No. after setting the access path using the ETERNUS SF Storage Cruiser.
Controller
DX/AF series
Using the predefined "Host Response Profile" with the name "BS2000" is recommended.
The standard BS2000 Host Response "BS2000" is preset with the correct parameter settings (incl. 4096
volumes / port).
Name
Byte-0 of Inquiry Response
Inquiry VPD ID Type
Inquiry Standard Data Version
Command Timeout Interval
Load Balance Response
Reservation Conflict Response for Test Unit Ready
Change Volume Mapping
Volume Capacity Expansion
Vendor Unique Sense Code
Host Specific Mode
Asymmetric / Symmetric Logical Unit Access
iSCSI Discovery Reply Mode
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection-
Connectivity > Host Response
Parameter
14
Copyright 2018 FUJITSU LIMITED
Category
BS2000
No Conversion (Default)
Type1 + Type3
Version 5 (Default)
Default (25sec.)
Unit Attention (Default)
Conflict
Report
Report
No Report (Default)
NR1000V Mode, 4096 LUNs: BS2000 Mode
ACTIVE / ACTIVE (Default)
All - Reply All ports (Default)
Action
Add Host Response
BS2000
P3AM-5672-10ENZ0