Figure 96 Connection Example Without A Dedicated Remote Support Port; Figure 97 Connection Example When The Ip Address Of The Slave Cm Is Set - Fujitsu ETERNUS DX500 S4/DX600 S4 Design Manual

4. Connection Configuration
LAN Connection
■
Connection Configurations
MNT ports are used for connecting a LAN for operation management.

Figure 96 Connection Example without a Dedicated Remote Support Port

Administration
terminal
IP address A
The following figure provides connection examples for when setting the IP address of the Slave CM.
Figure 97 Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote Support
Port Is Not Used)
Administration
terminal
IP address A
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Design Guide (Basic)
SNMP
E-mail server
manager
LAN switch
CM#0
Controller enclosure
ETERNUS DX
SNMP
E-mail server
manager
Syslog server
LAN switch
LAN for operation management
IP address B
CM#0
Controller enclosure
ETERNUS DX
Copyright 2019 FUJITSU LIMITED
NTP server
Authentication
Syslog server
server
LAN for operation management
RMT ports are not used.
CM#1
NTP server
Authentication
server
Remote support
center
RMT ports are not used.
The IP addresses of the Master CM
and the Slave CM are set.
CM#1
154
Remote support
center
P3AM-7722-25ENZ0