Monitoring Settings; Event Notification Setup - Fujitsu ETERNUS DX S5 Series Configuration Manual

8.

Monitoring Settings

Perform the ETERNUS DX monitoring setup if required.
For more details on the setup, refer to "ETERNUS Web GUI User's Guide".

Event Notification Setup

Select whether to report events detected in the ETERNUS DX. There are six methods for event notification: Host
Sense Key Code Qualifier, SNMP Trap, E-Mail, Syslog, REMCS, and AIS Connect.
Caution
If ETERNUS SF Storage Cruiser version 16.4 or later is used and configured to automatically obtain the
ETERNUS DX component status, event notifications by SNMP traps for some events are automatically
enabled.
The event notification items are as follows:
• Remote Path Error of no Data Transfer
• Recovery module
• Temperature restoration
• FC CA Port Link Status Changed
• iSCSI CA Port Link Status Changed
• Remote Path Recovery
• Events whose notification is enabled by default, but is disabled manually
If the ETERNUS DX is deleted from ETERNUS SF Storage Cruiser, event notifications by SNMP traps return to
the default state.
However, if the event notifications by SNMP traps are changed from the ETERNUS DX after they are
automatically changed by ETERNUS SF Storage Cruiser, the event notification setting is not returned to the
default state even if the ETERNUS DX is deleted from ETERNUS SF Storage Cruiser.
Check that there are no problems with the SNMP trap event notification setting for the ETERNUS DX.
The event notification setting is explained below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Event/Dump].
The [Event/Dump] screen appears.
3
In [Action], click [Setup Event Notification].
The [Setting based on Severity] tab screen of the [Setup Event Notification] screen appears.
159 Configuration Guide (Basic)