Table 29 Snmp Specifications - Fujitsu ETERNUS DX500 S4/DX600 S4 Design Manual

2. Basic Functions
Operation Management/Device Monitoring
●
Simple Network Management Protocol (SNMP)
Using the SNMP agent function, management information is sent to the SNMP manager (network management/
monitoring server).
The ETERNUS DX supports the following SNMP specifications.

Table 29 SNMP Specifications

Item
SNMP version
MIB
Trap
●
Syslog
By registering the syslog destination server in the ETERNUS DX, various events that are detected by the ETERNUS
DX are sent to the syslog server as event logs.
The ETERNUS DX supports the syslog protocol which conforms to RFC3164 and RFC5424.
●
Remote Support
The errors that occur in the ETERNUS DX are notified to the remote support center. The ETERNUS DX sends addi-
tional information (logs and system configuration information) for checking the error. This shortens the time to
collect information.
Remote support has the following maintenance functions.
• Failure notice
This function reports various failures, that occur in the ETERNUS DX, to the remote support center. The mainte-
nance engineer is notified of a failure immediately.
Information transfer
•
This function sends information such as logs and configuration information to be used when checking a fail-
ure. This shortens the time to collect the information that is necessary to check errors.
Firmware download
•
The latest firmware in the remote support center is automatically registered in the ETERNUS DX. This function
ensures that the latest firmware is registered in the ETERNUS DX, and prevents known errors from occurring.
Firmware can also be registered manually.
However, NAS system firmware is not automatically downloaded.
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Design Guide (Basic)
Specification
SNMP v1, v2c, v3
MIB II
FibreAlliance MIB 2.2
Unique MIB
Unique Trap
85
Copyright 2019 FUJITSU LIMITED
Remarks
—
Only the information managed by the ETERNUS DX can
be sent with the GET command.
The SET command send operation is not supported.
This is a MIB which is defined for the purpose of FC base
SAN management.
Only the information managed by the ETERNUS DX can
be sent with the GET command.
The SET command send operation is not supported.
This is a MIB in regard to hardware configuration of the
ETERNUS DX.
A trap number is defined for each category (such as a
component disconnection and a sensor error) and a mes-
sage with a brief description of an event as additional in-
formation is provided.
P3AM-7722-25ENZ0