Table 30 Snmp Specifications - Fujitsu ETERNUS AF250 Design Manual

1. Function
Operation Management/Device Monitoring
The ETERNUS AF supports the following SNMP specifications.

Table 30 SNMP Specifications

Item
SNMP version
MIB
Trap
●
Syslog
By registering the syslog destination server in the ETERNUS AF, various events that are detected by the ETERNUS
AF are sent to the syslog server as event logs.
The ETERNUS AF supports the syslog protocol which conforms to RFC3164 and RFC5424.
●
Remote Support
The errors that occur in the ETERNUS AF are notified to the remote support center. The ETERNUS AF sends addi-
tional information (logs and system configuration information) for checking the error. This shortens the time to
collect information.
Remote support has the following maintenance functions.
Failure notice
•
This function reports various failures, that occur in the ETERNUS AF, to the remote support center. The mainte-
nance engineer is notified of a failure immediately.
Information transfer
•
This function sends information such as logs and configuration information to be used when checking a fail-
ure. This shortens the time to collect the information that is necessary to check errors.
Firmware download
•
The latest firmware in the remote support center is automatically registered in the ETERNUS AF. This function
ensures that the latest firmware is registered in the ETERNUS AF, and prevents known errors from occurring.
Firmware can also be registered manually.
●
Host Sense
The ETERNUS AF returns host senses (sense codes) to notify specific status to the server. Detailed information
such as error contents can be obtained from the sense code.
Specification
SNMP v1, v2c, v3
MIB II
FibreAlliance MIB 2.2
Unique MIB
Unique Trap
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Design Guide (Basic)
Copyright 2019 FUJITSU LIMITED
Remarks
—
Only the information managed by the ETERNUS AF can be
sent with the GET command.
The SET command send operation is not supported.
This is a MIB which is defined for the purpose of FC base
SAN management.
Only the information managed by the ETERNUS AF can be
sent with the GET command.
The SET command send operation is not supported.
This is a MIB in regard to hardware configuration of the
ETERNUS AF.
A trap number is defined for each category (such as a
component disconnection and a sensor error) and a mes-
sage with a brief description of an event as additional in-
formation is provided.
83
P3AG-1822-09ENZ0