Configure Log Target Filter - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

configure log target filter

configure log target [console | memory-buffer | primary-msm | backup-msm |
nvram | session | syslog [all | <ipaddress> {vr <vr_name>} [local0 ...
local7]]] filter <filter-name> {severity <severity> {only}}
Description
Associates a filter to a target.
Syntax Description
target
console
memory-buffer
nvram
primary-msm
backup-msm
session
vr_name
syslog
all
ipaddress
local0 ... local7
filter-name
severity
only
Default
If severity is not specified, the severity level for the target is left unchanged. If a virtual router is not
specified, VR-Mgmt is used.
Usage Guidelines
This command associates the specified filter and severity with the specified target. A filter limits
messages sent to a target.
Although each target can be configured with its own filter, by default, all targets are associated with the
built-in filter, DefaultFilter. Each target can also be configured with its own severity level. This provides
the ability to associate multiple targets with the same filter, while having a configurable severity level
for each target.
A message is sent to a target if the target has been enabled, the message passes the associated filter, the
message is at least as severe as the configured severity level, and the message output matches the
regular expression specified. By default, the memory buffer, NVRAM, primary MSM, and backup MSM
targets are enabled. For other targets, use the command
describes the default characteristics of each type of target.
320
Specifies the device to send the log entries.
Specifies the console display.
Specifies the switch memory buffer.
Specifies the switch NVRAM.
Specifies the primary MSM.
Specifies the backup MSM.
Specifies the current session (including console display).
Specifies the virtual router that can reach the server IP address.
Specifies a syslog remote server.
Specifies all of the syslog remote servers.
Specifies the syslog IP address.
Specifies the local syslog facility.
Specifies the filter to associate with the target.
Specifies the minimum severity level to send (if the keyword only is omitted).
Specifies that only the specified severity level is to be sent.
on page 354. Table 10
enable log target
ExtremeWare XOS 11.0 Command Reference Guide