Show Ports Sharing - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

show ports sharing

show ports sharing
Description
Displays port load-sharing groups, or link aggregation groups (LAGs).
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
Output from this command displays the following information:
Config Master—The port that is configured as the master logical port of the link aggregation group
●
(LAG). This number is also the LAG group ID.
Current Master—In LACP, this is the port that is currently the LAG group ID, or master logical port
●
for the LAG.
Agg Control—This is the aggregation control for the specified LAG; it can be either static or LACP.
●
In LACP, it is the aggregation control for the specified LAG.
Ld Share Algorithm—The algorithm used for the link aggregation. The available link aggregation
●
algorithms vary among platforms; see the ExtremeWare XOS Concepts Guide for more information.
Ld Share Group—The specific ports that belong to each LAG, or the port numbers in the trunk. A
●
port can belong to only one LAG, either static or dynamic.
Agg Mbr—In LACP, this shows whether the port has been added to the aggregator or not; it will be
●
either Y for yes or - for no.
Link Status—This is the current status of the link
●
Link Up transitions—Number of times the link has cycled through being up, then down, then up.
●
Example
The following command displays link aggregation on the switch:
show ports sharing
The following is sample output from this command on the Summit X450 series switch:
Load Sharing Monitor
Config Current
Master Master
==============================================================================
5 5
ExtremeWare XOS 11.5 Command Reference Guide
Agg Ld Share
Control Algorithm
LACP L2
L2
Ld Share Agg Link
Group Mbr Status
5 Y A
6 Y A
show ports sharing
Link Up
transitions
3
3
401