Load_Sub - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command load_sub
Function Assigns the specified index to a subroutine defined by subsequent list commands and
loads the subroutine into the protected
load_sub( Index )
Call
Index
Parameters
Comments • Up to 1024 indexed subroutines can be stored. If Index > 1023 then load_sub is
ignored
• The address in the protected
should be stored is automatically determined and internally managed.
• Indexed subroutines must be terminated by a
actual storage of the commands, entry of the start address into the internal
management table, and initiating a flush of the buffered list input, see
"Loading Lists", page
list_return), the subroutine with this index is not available.
• An indexed subroutine is not stored if the protected
not been previously configured for a sufficient size beyond "List 1" and "List 2".
• If list_return
is deleted from the internal management table.
• Indexed subroutines can be called by the
corresponding index (see
page
• Observe all notes in
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References list_return, sub_call, load_char,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Index of the indexed subroutine.
As an unsigned 32-bit value.
Allowed value range: [0...1023].
(get_last_error return code RTC6_PARAM_ERROR).
RTC6 List Memory
105. Otherwise (the input pointer is altered without a preceding
is the next command after load_sub, then the corresponding subroutine
Section "General Information on Calling Subroutines",
114).
Section "Indexed Subroutines", page
load_text_table
RTC6 List Memory area "List 3".
area "List 3" where the subroutine
list_return call. This is a prerequisite for
RTC6 List Memory
sub_call command along with the
113.
Chapter 6.4.1
area "List 3" has
514