Scanlab RTC6 PCIe Board Installation And Operation Manual page 714

Normal List set_pixel_line
Command
Comments • The
(cont'd) See also
• The
Control" (see
readjustment of the port output, pulse length (PulseLength) or output period
(HalfPeriod) of the
• The
• The
However, a
requires
delay calculation must be switched on in addition. This allows pixel lines to be
positioned accurately. This
Sky Writing Mode 2
– Chapter 8.7.4 "Synchronization", page 268
– Chapter 7.2.4 "Sky Writing", page 160
• The
See also
• See also
RTC4RTC6 • For differences to the
page
• In RTC4 Compatibility
8 and those for dX and dY by 16. The allowed value ranges decrease accordingly.
RTC5RTC6 In "Classic Mode"
there are additional
Version info Last change DLL 604, OUT 604, RBF 609.
Additional
References set_default_pixel, set_default_pixel_list, set_pixel, set_n_pixel, set_pixel_line_3d,
set_port_default
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Pixel Output Mode can be combined with Processing-on-the-fly.
Chapter 8.6 "Processing-on-the-fly", page
Pixel Output Mode should not be used in conjunction with "Automatic Laser
Chapter 7.4.9 ""Automatic Laser Control"", page
Laser Control Signals
Pixel Output Mode is incompatible with the
Pixel Output Mode cannot be combined with
Sky Writing Mode
Sky Writing to be switched on. In case of a
Sky Writing
movements. See also:
Pixel Output Mode cannot be combined with Wobbel.
Chapter 8.4 "Wobbel Mode", page
Chapter 8.7 "Pixel Output Mode", page
Pixel Output Mode
56.
Mode, the RTC6 multiplies the specified value for HalfPeriod by
(RTC5 compatible), frequencies up to 400 kHz are possible. Furthermore,
Pixel Output
Pixel Output Modes: 16, 32, 64 and +512.
242.
LASER1 and LASER2.
Softstart Mode (not yet
Sky Writing.
1-like movement can be set by Mode + 512. This
SCANahead
movement cannot be combined with
and Figure 65
232.
263.
of the RTC4, see
Modes.
197), if there is a
implemented).
System, the automatic
Section "Special Functions",
714