Set_Defocus_Offset_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Variable

set_defocus_offset_list

List Command
Function Like set_defocus_offset, but a list command.
Restriction Like set_defocus.
set_defocus_offset_list( Shift )
Call
Shift
Parameters
Comments • See set_defocus_offset.
• See set_defocus_list.
• Even though set_defocus_offset_list is a short list command, execution of the directly
following list command is delayed by a few clock cycles due to the intermediate jump
to the changed z position. The extent of this delay depends on the size of the specified
focus shift; but it is at least 10 µs, even if Shift= 0.
RTC4RTC6 New command.
In RTC4 Compatibility
RTC5RTC6 Unchanged functionality.
In RTC5 Compatibility
Version info Available as of DLL 609, OUT 609, RBF 614.
References set_defocus_offset,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Like set_defocus.
Mode, the RTC6 multiplies the specified value for Shift by 16.
Mode, the RTC6 multiplies the specified value for Shift by 16.
set_defocus_list
627