Polygon Delay - Scanlab RTC6 PCIe Board Installation And Operation Manual

Polygon Delay

The Polygon Delay is specified by
set_scanner_delays with the
A typical course for a series of
("Polyline") where Polygon
Mark Delays) are inserted between the individual
Mark Command is shown in
Short list commands do not interrupt a Polyline.
If the (usually smaller) angles between the markings
vary only slightly usually a Polygon Delay
specified that is smaller than the
If, on the other hand, the angles vary significantly,
then a "Variable Polygon Delay" is recommended, see
Section "Variable Polygon Delays", page
Laser
LaserOn
Delay
1
0
Mark
command
Scan head control and laser control timing during a
RTC6 boards
Doc. Rev. 1.0.21 en-US
7 Basic Functions for Scan Head Control and Laser Control
Polygon
parameter.
Mark Commands
Delays (instead of
Figure 38.
value can be
Mark Delay value.
151.
Set Position
Real Position
Polygon Mark
Delay command
Polyline
LaserOff
Delay
Polygon Last Mark Mark
Delay command Delay
in this
polyline
with a constant Polygon Delay.
Time
...
Time
Jump
command
etc.
38
150