Scanlab RTC6 PCIe Board Installation And Operation Manual page 185

set_laser_pulses( HalfPeriod, PulseLength )
Specify output period and pulse length of
LASER1 and LASER2
in "Laser active" operation
set_standby( HalfPeriod, PulseLength )
Specify output period and pulse length of
LASER1 and LASER2
in "Laser standby" operation
load_program_file
resets
disable_laser
or
set_laser_control
of Bitmask)
(Bit #02 = 1
enable_laser
or
set_laser_control
of Bitmask)
(Bit #02 = 0
RTC6 board
hardware and laser control-related RTC6 commands.
RTC6 boards
Doc. Rev. 1.0.21 en-US
7 Basic Functions for Scan Head Control and Laser Control
RTC6-FPGA (chip)
generates internally
signals for "Laser active" operation &
signals for "Laser standby" operation
as specified (Example: CO ² Mode)
The signals for the "Laser active" operation and/or
"Laser standby" operation have been specified in advance
= NO
The signals for the "Laser active" operation and/or
"Laser standby" operation have been specified in advance
= YES
Transfer to the
pin for LASERON
pin for LASER1
pin for LASER2
LASERON
is BLOCKED
LASER1
LASER2
set_laser_control(Bitmask)
(specify polarity by
of Bitmask).
Bit #3 & Bit #4
The one time call unblocks irreversibly
Transfer to the
pin for LASERON
pin for LASER1
pin for LASER2
is irreversibly
UNBLOCKED
There are permanently
signals for
"Laser standby" operation
There is permanently
the „OFF" level
Case LASERON = "ON":
There are signals for
"Laser active" operation
Case LASERON = "OFF":
There are signals for
"Laser standby" operation
51
185