Set_Verify - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_verify
Function Activates or deactivates a download verification.
See Chapter 6.8.1 "Download Verification", page
OldVerify = set_verify( Verify )
Call
Verify
Parameters
The Verify setting parameter that has been active before calling set_verify.
Result
As an unsigned 32-bit value.
Comments • If verification is activated, the download times are extended.
• Verification of correction file downloads only works if the correction file contains a
checksum (otherwise the
To ensure that a checksum is present (which is not the case for older ct5
correction files), you should test your correction file prior to loading by using the
control command verify_checksum. If the correction file does not contain a check
sum, then
• set_verify is available even without explicit access rights to a specific RTC6 board.
set_verify only change settings in the
has no effect on the board itself.
• The board-specific error variables
Handling", page
• Activation of the download verification by set_verify can generate the
return code RTC6_OUT_OF_MEMORY, if a
In this case, the download verification remains deactivated.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References get_error, get_last_error,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Setting parameter.
As an unsigned 32-bit value.
= 0: Verification is deactivated.
> 0: Verification is activated.
get_last_error
verify_checksum enters it.
LastError
130) are neither generated nor altered by set_verify.
verify_checksum
131.
RTC6_VERIFY_ERROR
return code
RTC6 DLL of the specified (or default) board. It
AccError
and (see
RTC6 DLL-internal Windows memory request fails.
is generated).
Chapter 6.8 "Error
get_last_error
764