Scanlab RTC6 PCIe Board Installation And Operation Manual page 266

Table 5:
Mode Max. fre- No. of
quency pixels
per
set_pix
el/
set_n_
pixel
0, 400 kHz 1
(c)
256
16 800 kHz 2
(d)
32 1.6 MHz 4
(d)
64 3.2 MHz 8
(a) PulseLength in RTC6 Software Packages < v1.3.3.
(b) AnalogOut in RTC6 Software Packages < v1.3.3.
(c) The galvanometer scanner movement is not continuous in Mode = 0 and continuous in Mode = 256.
(d) > 800 kHz only possible with
RTC6 boards
Doc. Rev. 1.0.21 en-US
8 Advanced Functions for Scan Head Control and Laser Control
st
1 parameter of set_pixel/set_n_pixel
(a)
(name: PortOutValue1 )
Pixel 1 (defined by the pulse length).
The output is done as signal LASER1.
st
(1 parameter: 32-bit; 2
Port output for Pixel 1
(up to 32 bits per pixel, depending on port)
Pixel 1
Port output for Pixel 1, 2
(up to 16 bits per pixel, depending on port)
Pixel 2
Port output for Pixel 1, 2, 3, 4
(up to 8 bits per pixel, for all ports)
Pixel 4 Pixel 3
Bit 31................................................Bit 0
Option "UFPM".
nd
2
(name: PortOutValue2
Port output (but not port 5) for Pixel 1
Pixel 1
nd
parameter: up to 16 bit, depending on port)
Port output for Pixel 2
(up to 32 bits per pixel, depending on port)
Port output for Pixel 3, 4
(up to 16 bits per pixel, depending on port)
Pixel 1
Port output for Pixel 5, 6, 7, 8
(up to 8 bits per pixel, for all ports)
Pixel 2 Pixel 1 Pixel 8
Bit 31................................................Bit 0
parameter of set_pixel/set_n_pixel
(b)
)
Pixel 2
Pixel 4
Pixel 7 Pixel 6
Pixel 3
Pixel 5
266