Release_Wait - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command release_wait
Function Resumes processing of a list that has been interrupted by set_wait.

release_wait()

Call
Comments • release_wait is only executed if the RTC6 is actually in a wait state (hence if a break
point has been previously reached and list processing has been interrupted; the
PAUSED list execution status
Otherwise, release_wait is ignored
• By release_wait, the
and the
Status", page
• release_wait resets the
interrupt to zero.
• If a home jump (defined by
executed by set_wait, then release_wait leads to a corresponding home return
(the
• The wait state can be queried by get_wait_status.
RTC4RTC6 Basically unchanged functionality. However:
Additional
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_wait, get_wait_status,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
is then set but not the
PAUSED list execution status
BUSY list execution status
108.
WaitWord
home_position
INTERNAL-BUSY list execution status
PAUSED list execution status. It is set by
restart_list
BUSY list execution
(get_last_error return code RTC6_BUSY).
(queriable with get_status) is reset
is newly set, see also Chapter 6.4.3 "List Execution
that receives the break point number during an
or home_position_xyz) has been
is set while the home return is executed).
set_wait and reset with release_wait.
status).
592