Scanlab RTC6 PCIe Board Installation And Operation Manual page 564

Variable park_position
List Command
Comments • If the laser focus has been already previously moved to a safe park position, then
(cont'd) park_position is a short list command with no effect.
• park_position switches off the
LaserOff
RTC4RTC6 New command.
In RTC4 Compatibility
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
park_return
References
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Signals for "Laser Active" Operation
Delay, but does not activate a scanner delay afterward.
Mode, the RTC6 multiplies the specified values for X and Y by 16.
after a
564