Scanlab RTC6 PCIe Board Installation And Operation Manual page 541

Normal List mark_time
Command
Comments • mark_time reads (according to the stored time and according to the selected time
(cont'd) part) the starting address of the corresponding indexed text string (or – for
Part = 0...3 and Mode = 2 or 3 – of the corresponding indexed character) from the
internal management table and then calls
appropriate number of times, which starts the corresponding command list. The
command lists must contain marking instructions for digits 0...9 and for a.m./p.m, see
Section "Defining Indexed Text Strings for Time, Date and Serial Number", page
Non-defined text strings or characters are ignored (that is, not marked). The called
indexed text strings can also contain calls to indexed characters
mark_char_abs) and complete texts
the character set can be switched, if needed (before marking with mark_time), by
select_char_set, see also
• If Part > 4 and/or Mode > 3, then mark_time is, already during loading, replaced by a
list_nop (get_last_error
• Absolute
called with mark_time. If time markings need to execute at various locations within
the
contain relative
mark_time_abs
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References time_fix, time_fix_f, time_fix_f_off, load_text_table, set_text_table_pointer,
mark_time_abs
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Chapter 6.5.2 "Character Sets and Text Strings", page
return code RTC6_PARAM_ERROR).
Vector Commands and
Image Field, then the corresponding indexed text strings (or characters) can only
[*]mark[*] Commands,
must be used instead.
list_call (see also the comments there) an
or mark_text_abs). In the latter case,
(mark_text
"Arc" Commands execute absolutely after being
"Arc" Commands or
119.
(mark_char or
118.
Jump Commands or
541