Scanlab RTC6 PCIe Board Installation And Operation Manual page 958

Code Code
HIGH LOW
(hex) (hex)
05 27
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
Data type transmitted by the scan system
As of scan system firmware  2078.
Only after control_command(Data =
type
16-bit 20-bit
protocol protocol
Bit #8 Bit #12 = 0.
... ...
Bit #15 Bit #19
Bit #0 Bit #4 Cached setting.
... ...
Bit #7 Bit #11
– Bit #0 = 0.
...
Bit #3
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
17FF ): number of the temporarily stored data
H
958