Disable_Laser - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command disable_laser
Function Disables the

disable_laser()

Call
Comments • disable_laser disables the
LASER1, LASER2 and LASERON (the signals are set to their respective "Off" level).
Pin (02) of the
activated with
LASER1 and LASER2 output ports. If the standby signals are deactivated, also pin (01)
and pin (09) of the
socket connector are at a fixed level after disable_laser.
• The
reenabled by
• After initialization of the RTC6 with load_program_file, the laser control is
deactivated and absolutely requires
• If disable_laser results in an
been loaded), the LASER1, LASER2 and LASERON output ports can only be reactivated
with
• By get_startstop_info
(globally enabled, yes or no) can be queried.
• By get_startstop_info
queried.
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change: DLL 617, OUT 617:
References enable_laser, set_laser_control,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Signals for "Laser Active"
Signals for "Laser Active" Operation
LASER Connector
set_standby or
LASER Connector
Signals for "Laser Active" Operation
set_laser_control
RTC6_TIMEOUT
set_laser_control after a
Bit #9
(
Bit #14
(
get_startstop_info
Operation.
is then at a fixed level. However, standby signals
set_standby_list continue to be outputted by the
and pins (19) and (22) of the EXTENSION 2
can also be disabled by
or enable_laser.
set_laser_control
for activation.
error (for example, if no program file has
load_program_file command.
), the current status of the
), the status "laser enabled" (yes or no) can be
Bit #14
(
get_startstop_info
at the output ports
set_laser_control and
Laser Control Signals
).
351