Scanlab RTC6 PCIe Board Installation And Operation Manual page 691

Ctrl Command set_mcbsp_in
Comments • For deactivating Processing-on-the-fly correction, see
(cont'd) Processing-on-the-fly Correction", page
• 15 bits per axis (with sign) are effectively available for 2D correction (Mode = 3),
whereby the x value is in the lower 16 bits of the "Bit #31 = 0"-coded
value and the y value in the upper 16 bits.
• The
applications and
See also
• The
mcbsp_init. That is, data provided is not transmitted, see
• If Mode > 5, set_mcbsp_in is not executed
RTC6_PARAM_ERROR).
• If an unallowed Scale parameter value is supplied (for example, Scale = 0),
set_mcbsp_in behaves as with Mode = 0.
• Processing-on-the-fly corrections are compatible with the settings from
""Fly Extension" Commands", page 259
also be subsequently overwritten, for example, with encoder-based
Processing-on-the-fly corrections. The
Processing-on-the-fly corrections. However, the
above cannot be changed. If McBSP-based Processing-on-the-fly corrections other
than those set according to the Mode are set, the user is responsible for transferring the
McBSP
correction activated for the z axis is retained.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Last change DLL 617, OUT 617: compatibility with
References set_mcbsp_in_list
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
McBSP interface cannot be simultaneously used for both Processing-on-the-fly
Online Positioning.
Section "Notes", page
McBSP interface ignores the first FrameSync signal after a
data in the appropriate format. An encoder-based Processing-on-the-fly
Chapter 8.6.5 "Deactivating
251.
230.
(get_last_error
as of RTC6 Software Package V1.6.1. They can
McBSP values are then not used for
McBSP memory transfer described
"Fly Extension"
McBSP input
load_program_file
or
page 86.
return code
Chapter 8.6.12
Commands.
691