Scanlab RTC6 PCIe Board Installation And Operation Manual page 973

Code Code
HIGH LOW
(hex) (hex)
05 64
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Code Code
HIGH LOW
(hex) (hex)
05 65
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Code Code
HIGH LOW
(hex) (hex)
05 74
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
Data type transmitted by the scan system
As of scan system firmware  5100.
Refer to "excelliSCAN Scan Heads – Functional Principle of SCANahead Servo
Control and Operation by RTC6 Boards"
for "Spot Distance Control"", page
offset.
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
Data type transmitted by the scan system
As of scan system firmware  5100.
Refer to "excelliSCAN Scan Heads – Functional Principle of SCANahead Servo
Control and Operation by RTC6 Boards"
for "Spot Distance Control"", page
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
Data type transmitted by the scan system
As of scan system firmware  51*7 + < 5090.
For High-Bandwidth Return Channel
Code (hex) = 65 and
HIGH H
example code.
16-bit 20-bit –
protocol protocol
Bit #0 Bit #0 –
... ...
Bit #15 Bit #19
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
Manual, Chapter 3.4 "Advanced Settings
25: TimeShift relative to the SCANLAB default
Manual, Chapter 3.4 "Advanced Settings
25: TimeShift in total.
Multiplexing. For use in conjunction with
Code (hex) = 66 . See corresponding Chapter incl.
HIGH H
973