Scanlab RTC6 PCIe Board Installation And Operation Manual page 981

Code
HIGH
(hex)
As of scan system firmware  51*7 + < 5090.
65
For High-Bandwidth Return Channel
(hex) = 66
H
Code
LOW
(hex)
0N
8N
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Code
HIGH
(hex)
As of scan system firmware  51*7 + < 5090.
66
For High-Bandwidth Return Channel
(hex) = 65
H
Code
LOW
(hex)
NN
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
Multiplexing. For use in conjunction with
and 0574 . See corresponding Chapter incl. example code.
H
Sets Return Channel Multiplexing
that is, highest Return Channel Multiplexing
High-Bandwidth Return Channel Multiplexing
transmit.
Allowed values: 1; 2; 3; 4; 6; 8; 12; 16 (= integer divisor of 192  16).
Sets the next to-be-configured
In other words: Defines the position where the signal is transmitted.
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
Multiplexing. For use in conjunction with
and 0574 . See corresponding Chapter incl. example code.
H
Sets the return value for the current index to
index.
For NN, you can insert the same
Code = 00 (XY2-100 status
LOW H
(angular position of galvanometer
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
block length to N+1
index = N. In other words: number of
values the iDRIVE scan system has to
Return Channel Multiplexing
NN = writes the signal value to this
values as for SetMode, see
Code
LOW
word), Code = 01 (Actual position
LOW H
scanners)) etc.
Code
HIGH
index to N.
Code
HIGH
981