Scanlab RTC6 PCIe Board Installation And Operation Manual page 844

Multiple List wait_for_encoder_in_range_mode
Command
Function Waits until both encoder counters simultaneously lie within the specified range (including
limits).
wait_for_encoder_in_range_mode( EncXmin, EncXmax, EncYmin, EncYmax, Mode )
Call
EncXmin
Parameters
EncXmax
EncYmin
EncYmax
Mode
Comments • For usage, see
page 252
• See also comments on wait_for_encoder_in_range.
• Use Mode like in wait_for_encoder_mode:
– 0, 1 for
– 2 for
wait_for_encoder_in_range
•
wait_for_encoder_in_range_mode( Mode = ,0 ).
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 612, OUT 612, RBF 617.
References wait_for_encoder_mode
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Limit value.
As a signed 32-bit value.
Allowed value range: [–2
Like EncXmin (analogously).
Like EncXmin (analogously).
Like EncXmin (analogously).
Mode.
As a signed 32-bit value.
= 0 or 1: Waits for direct encoder values
("classical behavior").
= 2: Waits for encoder values that are expected to be present in
(set_scanahead_params
(SCANahead System
Chapter 8.6.7 "Synchronizing Processing-on-the-fly Applications",
and Chapter 9.3.3 "Synchronization by Encoder Signals", page
intelliSCAN or SCANahead
SCANahead Systems during an marking process
is synonymous with
31 31
...+(2 –1)].
parameter) PreviewTime
behavior).
Systems outside an marking process
298.
844