List_Repeat; List_Until - Scanlab RTC6 PCIe Board Installation And Operation Manual

Undelayed

list_repeat

Short List
Command
Function Initiates repetition of a group of list commands.
list_repeat()
Call
Comments • See
• Any still-pending delayed short list command executes first.
• All list commands between list_repeat and the next
multiple times.
• Each executed
Accordingly, the first list command after a repetition is executed with a 10 µs delay.
• Nesting up to 8
call beyond that limit is ignored as long as no
• If a list terminates (by
fully-processed
if an automatic list change (by auto_change,
active.
• Complete
between lists and subroutines or between different subroutines is not permitted.
Changing between lists is permitted as long as the list change occurs without explicit
list termination (by an automatic list change or by an explicit list jump to another list
with list_jump_pos).
• List jumps into a
loop-external location should be avoided. Careless use could compromise loop
management integrity so severely that loops do not execute as expected. But
subroutine calls from inside a loop are always reliably possible.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References

list_until

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Chapter 6.5.5 "Loops", page
list_repeat...list_until
list_repeat...list_until
set_end_of_list
list_repeat...list_until
list_repeat...list_until
list_repeat...list_until
122.
list_until
loop requires a full 10 µs clock cycle.
loops deep is allowed. Each further list_repeat
list_until call has terminated a loop.
or stop_execution or /STOP), then all not-yet-
loops are deleted. However, this does not occur
auto_change_pos
loops can reside within a list or subroutine. Changing
loop body or from inside a loop to a
call is possibly repeated
or start_loop) is
488