Scanlab RTC6 PCIe Board Installation And Operation Manual page 846

Normal List wait_for_encoder_mode
Command
Comments • The active Processing-on-the-fly mode determines whether the galvanometer scanners
(cont'd) remain stationary during the wait or move in accordance with encoder changes, see
Chapter 8.6.7 "Synchronizing Processing-on-the-fly Applications", page
move with set_fly_2d, but otherwise remain stationary.
• Mode = 0 or
• Mode =
(set_scanahead_params
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References get_encoder, store_encoder, read_encoder, simulate_encoder, wait_for_encoder,
wait_for_encoder_in_range, park_position,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
±
1 waits for direct encoder values: "classic" behavior.
±
2 waits for encoder values that are expected to be present in
parameter) PreviewTime:
SCANahead System
park_return
252: They
behavior.
846