Scanlab RTC6 PCIe Board Installation And Operation Manual page 670

Ctrl Command set_laser_control
Comments • For the RTC5/RTC6 predecessors, the laser control signal levels are defined by solder
(cont'd) jumpers. The RTC5/RTC6 lets users control them completely by software.
get_startstop_info
whether the signals are set to active-HIGH or active-LOW
• Enabling and disabling of
or disable_laser.
get_startstop_info
By
• Even if the
they are not outputted without further commands, see
page
• The phase shift of the
synchronization of an analog output, for example, in
implemented)
page
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 617, OUT 617, RBF 623:
set_laser_mode,
References
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
queries the current status of the
Laser Control Signals
( Bit #14
Laser Control Signals
184.
Laser Control Signals (Bit #1
or the Pixel Output
263.
config_laser_signals
Laser Control Signals (Bit
can also be achieved by
) the current state can be queried.
were enabled with set_laser_control or enable_laser,
Chapter 7.4 "Laser Control",
= 1) can be set for better
Softstart Mode (not yet
Mode, see Chapter 8.7 "Pixel Output Mode",
get_startstop_info
#9) and
(Bit #13).
enable_laser
( Bit #14 ) support.
670