Scanlab RTC6 PCIe Board Installation And Operation Manual page 504

Ctrl Command load_jump_table_offset
Result 10
(cont'd)
11
13
Comments • For information on command usage, see
Jump Delays", page
• See also
• Format requirements for placing the table with
file are described in
page
appropriate values for the complete jump length range.
• load_jump_table_offset overwrites any previously loaded
Jump
• If Name = filename, then the table number No is loaded. The other parameters are not
used.
• If Name = NULL, then the
loaded (if
set_jump_mode
and ListPos are used (see
page
• Jump Mode
enabled by
• load_jump_table_offset is not executed
– the
– the
• load_jump_table_offset is even executed, if:
– a list has been paused by
• During the runtime of load_jump_table_offset,
• Before loading a table, load_jump_table_offset performs a
produces error code 4 in case of error.
• The table can be saved by create_dat_file.
RTC4RTC6 New command.
There is no
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Reference load_jump_table, set_jump_mode, set_jump_mode_list, get_jump_table,
set_jump_table,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Only if Name = NULL: Param error: HeadNo or ListPos invalid.
PCI error during download
The specified table number could not be found in the file.
218.
Chapter 8.1.5 "Jump Mode", page
Section "Notes on Loading Determined Jump Delay Values",
219. When loading the table, the RTC6 uses linear interpolation to establish
Mode.
Jump Delay
Jump Mode has been previously enabled and activated successfully by
(Flag = 1)). Here, the parameters PosAck, Offset, MinDelay, MaxDelay
Section "Automatic Determination of the Jump Delay Table",
221).
takes effect upon the next 2D jump only if it has been activated and
set_jump_mode or activated by set_jump_mode_list.
BUSY list execution status
INTERNAL-BUSY list execution status
set_wait (PAUSED list execution status
RTC4 Compatibility Mode
create_dat_file
return code RTC6_SEND_ERROR).
(get_last_error
Section "Jump-Length-Dependent
217.
Jump Delay
table for head No is automatically determined and
return code RTC6_BUSY), if:
(get_last_error
is set
is set
External Starts are suppressed.
for this command.
data points into the text
Jump Delay tables for
set)
DSP memory check that
504