Synchronous Starts And Synchronous Stops - Scanlab RTC6 PCIe Board Installation And Operation Manual

Synchronous Starts and Synchronous Stops

Within a master/slave chain,
enabled with set_control_mode) and
are passed on:
• from one board to all boards
Therefore, it can be triggered:
• A synchronous start of all synchronized boards
within a master/slave chain (with presettable
track delays) can be triggered by an external start
signal, a simulate_ext_start
simulate_ext_start_ctrl
• A synchronous stop of all synchronized boards
within a master/slave chain
by an external stop signal or a
at any board
In contrast, not passed on are:
• Starts by execute_list
• Starts by execute_at_pointer
• Stops by stop_execution
Therefore, these must be separately executed even at
master/slave-synchronized boards.
RTC6 boards
Doc. Rev. 1.0.21 en-US
6 Developing RTC6-User Programs
External Starts (if
External Stops
or a
at any board
simulate_ext_stop
Notes
• See also Chapter 9.3.1 "Starting and Stopping
Lists by External Control Signals and Master/Slave
Synchronization", page
• With master_slave_config
interface properties can be configured
individually for each RTC6 board.
289.
the master/slave
126