Get_Master_Slave - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command get_master_slave
Function Returns the master/slave status of the addressed RTC6 board.
MasterSlaveStatus = get_master_slave()
Call
Result Master/slave status.
As an unsigned 32-bit value.
Information whether a further RTC6 board is connected to the Master or Slave connector
of the addressed RTC6 board:
Bit #0
(LSB)
Bit #1
Bit #2
...
Bit #31
Information, whether the addressed board is operated as a master, slave or single board:
= 0
= 1
= 2
= 3
Comments • See
• get_master_slave only returns the status, if the addressed RTC6 board has been
previously initialized by load_program_file. Otherwise, 0 is returned.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References sync_slaves
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
= 1: A RTC6 board is connected to the Slave connector.
= 1: A RTC6 board is connected to the Master connector.
= 0.
...
= 0.
Single board.
Slave without any further downstream slave board.
Master.
Slave together with a downstream slave board.
Chapter 6.6.3 "Master/Slave Operation", page 124.
417