Scanlab RTC6 PCIe Board Installation And Operation Manual page 974

Code
HIGH
(hex)
As of scan system firmware  2078.
0A
UpdatePermanentMemory
UpdatePermanentMemory
startup behavior for subsequent restarts or resets.
See also Chapter 8.1.8 "Configuring the Start Behavior", page
As of scan system firmware  5050.
Only excelliSCAN:
excelliSCAN scan heads do not support UpdatePermanentMemory.
Code
LOW
(hex)
00
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
causes the scan system to set the current servo behavior as the
Only allowed value.
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
223.
974