Scanlab RTC6 PCIe Board Installation And Operation Manual page 865

Ctrl Command select_list
Support status This RTC4 command is not supported by the RTC6.
RTC4RTC6 select_list(0) can be replaced by set_extstartpos(0), select_list(1) by
set_extstartpos(Mem1). Thereby,
address of "List 2"). After initialization (with load_program_file),
as set by config_list.
"ownership") by
Ctrl Command set_list_mode
Support status This RTC4 command is not supported by the RTC6.
RTC4RTC6 See Chapter 6.5.4 "RTC4-Circular Queue Mode", page
Ctrl Command set_piso_control
Support status This RTC4 command is not supported by the RTC6.
RTC4RTC6 This command is not needed for operation of the RTC6.
For data transfer in accordance with the SL2-100 protocol, the bi-directional
communication between the scan system and the RTC5/RTC6 does not depend on the data
cable length.
For data transfer in accordance with the XY2-100 protocol, the timing of the
communication must be further on adjusted to reflect the length of the data cable; but
the adjustment is now realized by a jumper at the
Ctrl Command set_wobbel_xy
Support status This RTC4 command is not supported by the RTC6.
Replaced by set_wobbel,
Ctrl Command z_out
Support status This RTC4 command is not supported by the RTC6.
RTC4RTC6 For setting the z value in a 3-axis scan system,
an RTC6 with enabled
the same effect as z_out(Z) (see also set_offset_xyz).
List Command z_out_list
Support status This RTC4 command is not supported by the RTC6.
RTC4RTC6 After load_z_table(0.0, 1.0, 0.0), set_defocus_list(Z) has the same effect as z_out_list(Z)
(see also set_offset_xyz_list).
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Mem1
is the memory size of "List 1" (and the absolute start
Mem1 can be determined (for example, after a board changed
set_start_list_2 and get_input_pointer.
set_wobbel_mode
"3D"). After load_z_table(0.0, 1.0, 0.0), set_defocus(Z) has
Option
Mem1
121.
XY2-100 Converter (Accessory).
set_defocus can be used (only together with
is 4000, otherwise
865