Get_Waveform - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command get_waveform
Like get_waveform_offset, but without parameter Offset.
Function
get_waveform( Channel, Number, Ptr )
Call
Channel
Parameters
Number
Ptr
Comments • No data are transferred
– For Number = 0
– For Number > 2
– For Number > 2
– For Number > 2
– For Number > 2
– For Number > 2
– For Ptr = NULL.
• get_waveform is synonymous with:
– get_waveform_offset( Channel, 0, Number,
• Comments, page 441
RTC4RTC6 Basically unchanged functionality. However:
Even in
transferred to the PC as 32-bit values (see comments for get_value).
RTC5RTC6 Basically unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 635, OUT 636: Channel. Allowed values extended to 8 (previously: 4).
References set_trigger, set_trigger4, set_trigger8, get_value, get_values,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Like get_waveform_offset.
Number of measured values to be transferred.
Allowed value range: [0...max. channel size, see
set_trigger/set_trigger4/set_trigger8].
The measured values from position 0 to (Number–1) are transferred.
As an unsigned 32-bit value.
Like get_waveform_offset.
(get_last_error
22
, if the recording has been started by
23
× 4 and Channel = 1
23
× 2 and Channel = 2
23
× 3 and Channel = 3
23
× 1 and Channel = 4
on get_waveform_offset
RTC4 Compatibility Mode, all values are in the RTC6 20-bit range, but are
return code RTC6_PARAM_ERROR):
set_trigger8
Ptr )
apply analogously.
get_waveform_offset
447