Set_Sky_Writing_Limit; Set_Sky_Writing_Limit_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_sky_writing_limit
Function Defines the limit for
set_sky_writing_limit( Limit )
Call
Limit
Parameters
Comments • For usage of set_sky_writing_limit, see
• Limit is the cosine of the angular limit (for angular change between consecutive
vectors or arcs within a Polyline) for which a
• The initialized value (after program start) is Limit = 0 (angular limit = 90°).
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References

set_sky_writing_limit_list

Undelayed set_sky_writing_limit_list
Short List
Command
Function Like set_sky_writing_limit, but a list command.
set_sky_writing_limit_list( Limit )
Call
Limit
Parameters
Comments • See set_sky_writing_limit.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References

set_sky_writing_limit

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Sky Writing switching in
Limit value.
As a 64-bit IEEE floating point value.
Allowed value range: [–1.0...+1.0].
Out-of-range values are clipped to the boundary values.
Like set_sky_writing_limit.
Sky Writing Mode 3.
Chapter 7.2.4 "Sky Writing", page
Sky Writing motion should be performed.
160.
735