Laser Marking; Special Functions - Scanlab RTC6 PCIe Board Installation And Operation Manual

Laser Marking

• Vectors and arcs
– Commands for marking ellipses, see
"Ellipse Commands", page 138
– Commands for marking helices, see
"3D Commands", page 238
– Timed arc commands, timed 3D vector
commands, see Chapter 8.9
"Timed Commands", page 274
– Para-Mark Commands and Para-
Jump Commands for "vector-controlled laser
control", see Section "Vector-Defined Laser
Control", page 206
• Characters and texts
– Defining character sets and text strings, see
Section "Defining Indexed Character Sets",
page 118
– Commands for marking individual characters
and for marking texts (with selectable character
set), see Section "Calling Indexed Characters",
page 119
– Commands for marking dates, times and serial
numbers (with selectable character set and
selectable serial-number-set), see
"Marking Dates, Times and Serial Numbers",
page 210
• micro_vector[*] Commands (direct position
output without Microstepping), see
"micro_vector[*] Commands", page
RTC6 boards
Doc. Rev. 1.0.21 en-US
2 Product Overview

Special Functions

• Synchronization of scan system and laser control
Section – Sky
page 160
Chapter
• Pixel Output Mode
Chapter 8.7 "Pixel Output Mode", page
– Pixel output frequencies up to 800 kHz, beyond
that with
– RTC4-Pixel Mode
synchronous output is no longer supported
– 15 ns resolution
– 0...100% laser pulse length
– Pixel-Mode 0 not supported
– Reading of analog voltages is not supported
– 3D pixel lines with
• Commands for conditional execution of any
list command, see
Command Execution", page 295
• Possible wobbel motion shapes include not only
circles, but also ellipses, horizontal figure-of-8s,
vertical figure-of-8s, and "freely definable wobbel
shapes". Options for the orientation of the
wobbel shapes are: stationary in space,
Chapter 7.5
continuously and automatically adjusted to the
current direction of motion, or any other freely
assigned motion direction. With
Wobbel
Chapter 8.8
varied, see
273.
page 232
• Camming
"Camming", page 279
• Enhanced signal recording, see
set_trigger/set_trigger4/set_trigger8
Writing, see Chapter 7.2.4 "Sky Writing",
(marking of bitmaps), see
Option "UFPM" up to 3.2 MHz
0 with 10 µs clock
set_pixel_line_3d
Chapter 9.3.2 "Conditional
Shapes", also the laser power can be
Chapter 8.4 "Wobbel Mode",
functionality, see Chapter 8.11
263:
"Freely Definable
56