Jump_Abs_Drill_2 - Scanlab RTC6 PCIe Board Installation And Operation Manual

Normal List jump_abs_3d
Command
Function Moves the output point (of the laser focus) along a 3D vector at jump speed from the
current position to the specified position (absolute coordinate values) within the
3D Image
Restriction If the Option "3D"
select_cor_table), then jump_abs_3d has the same effect as jump_abs. However, split-
up into
jump speed in the xy plane.
jump_abs_3d( X, Y, Z )
Call
X
Parameters
Y
Z
Comments • Except for the additional motion in the third dimension, jump_abs_3d functions
similarly to
• The
(linear or with stepwise correction).
RTC4RTC6 Unchanged functionality. In addition: increased value range.
In RTC4 Compatibility
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality. In addition: increased value range.
In RTC5 Compatibility
The allowed value range decreases accordingly.
Version info Available as of DLL 600, OUT 600, RBF 600.
References jump_abs, jump_rel_3d,
Normal List jump_abs_drill
Command
jump_abs_drill( X, Y, DrillTime )
Call
Comments • This command is described, for example, in the manual for the intelliDRILL
Module.
Normal List

jump_abs_drill_2

Command
jump_abs_drill_2( X, Y, DrillTime, XOff, YOff )
Call
Comments • This command is described, for example, in the manual for the intelliDRILL
Module.
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Field.
is not enabled or no 3D correction table has been assigned (see
Microsteps is calculated like a 3D command and hence influences the effective
Absolute x coordinate of the jump vector end point. In bits.
As a signed 32-bit value.
Allowed value range: [–268,435,456...+268,435,455].
Out-of-range values are clipped to the boundary values.
The complete value range is only usable as a virtual
for (enabled) Processing-on-the-fly applications.
Like X (analogously).
Like X (analogously), except
Allowed value range: [–524,288...+524,287].
jump_abs (see comments there).
DirectMove3D
parameter of
Mode, the RTC6 multiplies the values specified for X, Y and Z by 16.
Mode, the RTC6 multiplies the value specified for Z by 16.
timed_jump_abs_3d
set_delay_mode determines the type of z axis motion
Image Field for example,
II 20
de
II 20
de
467