Eth_Check_Connection - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command eth_check_connection
Function Checks whether the RTC6 Ethernet Board responds.
CheckOK = eth_check_connection()
Call
Parameters None.
Result Response behavior.
As an unsigned 32-bit value.
0:
1:
• When CheckOK = 0 , the possible error cause can be queried by get_last_error,
Comments
eth_get_last_error
• If the board is not an RTC6 Ethernet Board, then:
– eth_check_connection is not executed
– get_last_error
• See also
page
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 608, OUT 608, RBF 611.
References eth_get_error, eth_get_last_error,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Not OK. The RTC6 Ethernet Board does not have an Ethernet connection,
it does not respond or it is not an RTC6 Ethernet Board.
OK. The RTC6 Ethernet Board has an Ethernet connection and it responds.
and eth_get_error.
RTC6_TYPE_REJECTED
return code
Chapter 16.5.4 "Checking the Connection to the RTC6 Ethernet Board",
906.
is set
get_last_error
356