Scanlab RTC6 PCIe Board Installation And Operation Manual page 536

Normal List mark_serial
Command
Comments • If Digits = 0, then a "markless" marking is executed. If M
(cont'd) is incremented by 1 (any increment size defined by
set_serial_step_list
number is to be omitted (repeat n times if necessary; n = increment), but can also be
used to indirectly increase the serial number by an additional increment.
• For each to-be-marked serial number digit, the mark_serial command reads the
starting address of the corresponding indexed text string (or – for M
corresponding indexed character) from the internal management table and then calls
list_call
the corresponding command lists. The command lists must contain marking
instructions for digits 0...9 (see
and Serial Number", page
(that is, not marked). The called indexed text strings can also contain calls to indexed
characters
mark_text_abs). In the latter case, the character set can be switched if needed (before
marking by mark_serial) with
and Text Strings", page
• For invalid Mode values, the mark_serial is, already during loading, replaced by a
list_nop (get_last_error
• Absolute
called with mark_serial. If serial number markings need to execute at various locations
within the
only contain relative
mark_serial_abs
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_serial, set_serial_step, set_serial_step_list, get_list_serial, set_max_counts,
get_counts, load_text_table, set_text_table_pointer,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
are not used in this case!). This can be useful, if a single serial
(see also the comments there) an appropriate number of times, which starts
Section "Defining Indexed Text Strings for Time, Date
119). Non-defined text strings or characters are ignored
(mark_char or mark_char_abs) and complete texts
select_char_set
118).
return code RTC6_PARAM_ERROR).
Vector Commands and "Arc"
Image Field, then the corresponding indexed text strings (or characters) can
[*]mark[*] Commands,
must be used instead.
= 0, then the serial number
2
set_serial_step
(mark_text
(see also Chapter 6.5.2 "Character Sets
Commands execute absolutely after being
"Arc" Commands or
mark_serial_abs
or
= 1 – of the
1
or
Jump Commands or
536